2007 Arctic Cat ATVs factory service and repair manual, Page 437Get this manual

2007 Arctic Cat ATVs factory service and repair manual, Page 437

3Making sure the body mounting grommets are in place, position the front and rear racks; then install the eight flanged cap
with part-cleaning solvent and soap and water 2Inspect fenders for cracks andor loose rivets3Inspect for any missing decalsINSTALLING
1Place the body assembly into position on the ATV1 NOTE: If the front and rear body panels have been separated, proceed to
step 2; if the panels have not been separated, proceed to step 3 4Install four rack-to-body machine screws and lock nuts
on the front and rear racks, two push nuts behind the grille, and two body bolts adjacent the air filter housing: then tighten