2007 Arctic Cat ATVs factory service and repair manual, Page 441Get this manual

2007 Arctic Cat ATVs factory service and repair manual, Page 441

It may be necessary to rotate the body panel to the right to align the opening with the handlebari NOTE: 3Make sure the four
then place the front body panel over the handlebar and rotate and lower into position 4Install one machine screw and flange
nut and four plastic rivets on each side to secure the front fenders to the footwellsTighten the flange nuts securely1 NOTE:
If the footwells have been removed, see Footrests in this section 5Install four cap screws securing the front body panel
to the frame and rear panel 2Connect the headlight connectors to the appropriate headlights and the front accessory plug