2007 Arctic Cat ATVs factory service and repair manual, Page 445Get this manual

2007 Arctic Cat ATVs factory service and repair manual, Page 445

INSTALLING 1If the front body panel has not been 1Remove the gas tank cap and set the rear body panel in position; then install
off the ATVCD690A 3Install one shoulder screw and three plastic rivets (on each side) to secure the front of the rear body
panel to the footwells 3Remove the two cap screws (located inside the side storage box) securing the box to the footrest4Remove
the screw securing the box to the side panel 5Remove cap screws (A and B) securing the box to the frame 4Place the battery
into the battery box; then connect the battery (positive cable first) and secure with the battery cover CLEANING AND INSPECTING
1Whenever part is worn excessively, cracked, or damaged in any way, replacement is necessary 1Clean all side storage box
components with soap and water 2Inspect the box for cracks, tears, and loose mounting hardware3Inspect the box hatch O-ring