2007 Arctic Cat ATVs factory service and repair manual, Page 450Get this manual

2007 Arctic Cat ATVs factory service and repair manual, Page 450

Hand Brake Lever Master Cylinder Assembly 1NOTE: The master cylinder is non-serviceable component; it must be replaced as
crush washers and banjo-fitting bolt INSPECTING 1NOTE: Whenever part is worn excessively, cracked, or damaged in any way,
replacement is necessary 1Inspect the pin securing the brake lever for wear2Inspect the brake lever for elongation of the
pivot hole3Inspect the reservoir for cracks and leakage 4Inspect the banjo-fitting for cracks and deterioration and the condition
of the fittings (threaded and compression) 5Inspect the brakelight switch for corrosion, Brake fluid is highly corrosiveDo
not spill brake fluid on any surface of the ATV cracks, missing or broken mounting tabs, or broken and frayed wiring 3Remove
the circlip and pivot in securing the brake lever to the master cylin er housing; then remove the brake lever and set aside