2007 Arctic Cat ATVs factory service and repair manual, Page 451Get this manual

2007 Arctic Cat ATVs factory service and repair manual, Page 451

INSTALLING 1Position the brake housing on the handlebarSecure with clamp screws; then tighten securely Throttle Control REMOVING
to the master cylinder; then secure with the banjo-fitting bolt 3Remove the cap screw, lock washer, and washer securing the
actuator arm to the throttle control lever 3Gently press the brakelight switch into the housing (left to right) until the
mounting tabs snap into the four locating holes; then install the brake lever, pivot pin, and circlip 4Remove the actuator