2007 Arctic Cat ATVs factory service and repair manual, Page 453Get this manual

2007 Arctic Cat ATVs factory service and repair manual, Page 453

Gearshift Pedal (Manual Transmission) A CAUTION Do not attempt to either engage or disengage the front differential while
The automatic drive selector allows the operator to operate in either 2-wheel drive (rear wheels) or 4-wheel drive (all wheels)For
normal riding on flat, dry, hard surfaces, 2-wheel drive should be sufficientIn situations of aggressive trail conditions,
4-wheel drive would be the desired choiceTo either engage or disengage the front wheels, move the switch to the 4WD position
or to the 2WD position To adjust the differential lock cable, see Section 2 Shift Lever REMOVING 1Remove the E-clip securing
the shift rod to the engine shift arm2Remove two cap screws, two self-tapping screws, and three nylon ties securing the left-side
splash panel and remove the panel Selector Switch 3Remove the axle and nut securing the shift lever to the upper shift arm;
then remove the shift leverAccount for spring and two O-rings 4Using two open-end wrenches, remove the lock nut securing