2007 Arctic Cat ATVs factory service and repair manual, Page 454Get this manual

2007 Arctic Cat ATVs factory service and repair manual, Page 454

INSTALLING 1Place the shift rod into position on the engine shift arm and secure with the existing E-clip2Using new lock
the multi-pin connector 3Mount the speedometer and secure with the two nuts; then connect the multi-pin connectorAF941A Place
the spring into position between the upper shift arm and shift lever; then making sure the O-rings are in place on the axle,
secure the shift lever to the arm with the existing axle and nutCheck shift lever adjustment (see Section 2); then tighten
jam nut (A) securelyInstall the left-side splash panel 4Install the instrument pod and secure with the reinstallable rivets5Secure