2007 Arctic Cat DVX/Utility 250 ATV Service Manual, Page 5Get this manual

2007 Arctic Cat DVX/Utility 250 ATV Service Manual, Page 5

Break-In Procedure A new ATV and an overhauled ATV engine require "break-in" periodThe first 10 hours (or 200 miles) are
however, brief full-throttle accelerations and variations in driving speeds contribute to good engine break-inDuring the
break-in period (or whenever the brake pads are replaced), the hydraulic brake pads must be burnishedSlow disc-speed hydraulic
brakes must be properly burnished in order to achieve maximum stopping power ! WARNING Do not attempt sudden stops or put
the ATV into situation where sudden stop will be required until the brake pads are properly burnished NOTE: Do not be reluctant
to heat up the brake pads during the burnishing procedure After the completion of the break-in period, the engine oil and
oil filter should be changedOther maintenance after break-in should include checking of all prescribed adjustments and tightening
of all fasteners GasolineOil Lubricant RECOMMENDED GASOLINE The recommended gasoline to use is 87 minimum octane regular
unleadedIn many areas, oxygenates (either ethanol or MTBE) are added to the gasolineOxygenated gasolines containing up to