2007 Arctic Cat DVX/Utility 250 ATV Service Manual, Page 27Get this manual

2007 Arctic Cat DVX/Utility 250 ATV Service Manual, Page 27

4Remove the nut securing the movable drive face; then remove the faceAccount for the stepped washer and spacer 3Install
drive sheave or crankshaft damage could occur 1Using rubber mallet, spread the driven pulley sheaves by driving the V-belt
down between the sheaves; then slide the driven pulley and V-belt into position 4Install the V-belt cover and tighten the
cap screws securely; then connect the cooling boots and tighten the clamps securely ! CAUTION On the DVX model, the rear
boot clamp must be oriented as shown or interference with heat shielding could occur 2Install the centrifugal clutch housing
onto the driven shaft; then install the splined bushing and secure with the driven pulley retaining nutTighten to specifications