2007 Arctic Cat DVX/Utility 250 ATV Service Manual, Page 32Get this manual

2007 Arctic Cat DVX/Utility 250 ATV Service Manual, Page 32

Table of Contents Removing EngineTransmission 3-4 Top-Side Components3-10 Removing Top-Side Components 3-10 Left-Side Components
can be performed without removing the enginetransmission from the frameClosely observe the note introducing each sub-section
for this important information 4Remove the gas tank cover panel; then install the gas tank cap and remove the gas tank vent
hose5Remove the body (see Section 8)6Remove the air filter housing (see Section 4)7Remove the gas tank (see Section 4)8Remove
the muffler assembly (see Section 8)9Remove the carburetor (see Section 4)10Remove the coil (see Section 5)11Disconnect the
stator connector, shift position connector, and coolant temperature sensor AT THIS POINT If the technician's objective is
to servicereplace left-side cover oil seals, the enginetransmission does not have to be removed from the frame Secure the
ATV on support stand to elevate the wheels ! WARNING Make sure the ATV is solidly supported on the support stand to avoid