2007 Arctic Cat DVX/Utility 250 ATV Service Manual, Page 45Get this manual

2007 Arctic Cat DVX/Utility 250 ATV Service Manual, Page 45

12To disassemble the driveshaft, use the following procedureARemove the thrust washer; then remove the reverse gear 13To
BRemove the nut securing the driven bevel gear; then remove the gearAccount for washer CRemove the low driven gear snap ring
and washer; then remove the low driven gear and thrust washer CRemove the shaft and housing from the universal joint and
remove the shaft from the housingNOTE: If left-side components are still attached, remove the centrifugal clutchdriven pulley