2007 Arctic Cat DVX/Utility 250 ATV Service Manual, Page 46Get this manual

2007 Arctic Cat DVX/Utility 250 ATV Service Manual, Page 46

BWater Pump CStator Coil DTrigger Coil ERotorFlywheel AT THIS POINT To removeservice the water pump, see section 4 9Remove
service the stator coil, see Section 5 AT THIS POINT To service the trigger coil, see Section 5 12Remove the oil-through
and spring from the end of the crankshaft; then hold the rotorflywheel with an appropriate holding tool and remove the flywheel
nut and washer FOil Pump NOTE: Steps 9-13 in the preceding sub-section must precede this procedure 14Remove the rotorflywheel
(see RotorFlywheel in this sub-section)15Remove the starter drive gear and place together with the rotorflywheel to keep
the one-way clutch bearing intact 13Install the flywheel puller and crankshaft protector; then remove the rotorflywheelAccount