2007 Arctic Cat DVX/Utility 250 ATV Service Manual, Page 61Get this manual

2007 Arctic Cat DVX/Utility 250 ATV Service Manual, Page 61

2Zero the indicator and push the small end of the connecting rod away from the dial indicator3Maximum deflection must not
Measuring Connecting Rod (Small End Inside Diameter) 3Acceptable gap range must be within specificationsMeasuring Connecting
Rod (Big End Width) 1Insert snap gauge into the upper connecting rod small end bore; then remove the gauge and measure it
with micrometer 1Using calipers, measure the width of the connecting rod at the big-end bearing2Acceptable width range must
be within specificationsMeasuring Crankshaft (Runout) 1Place the crankshaft on set of blocks2Mount dial indicator and base
on the surface platePosition the indicator contact at point of the crankshaftCC290D 2Maximum diameter must not exceed specificationsMeasuring