2007 Arctic Cat DVX/Utility 250 ATV Service Manual, Page 68Get this manual

2007 Arctic Cat DVX/Utility 250 ATV Service Manual, Page 68

19Loosely secure the secondary driven bevel gear assembly using the four cap screws; then using crisscross pattern, tighten
until snug Assembling Crankcase Half NOTE: For ease of assembling, install components on the left-side crankcase half NOTE:
Rotate the crankshaft back and forth to ensure no binding or sticking occurs while tightening the cap screws To assemble
center crankcase components, install the balance shaft into the left-side crankcase half; then align the timing mark on the
balance shaft with the timing mark on the crankshaftInstall the crankshaftMD1008 4From the left side, install the remaining
crankcase cap screws; then tighten only until snugNOTE: Rotate the crankshaft back and forth to ensure no binding or sticking