2007 Arctic Cat DVX/Utility 250 ATV Service Manual, Page 69Get this manual

2007 Arctic Cat DVX/Utility 250 ATV Service Manual, Page 69

BRotorFlywheel CTrigger Coil DStator Coil 4Install the starter idler shaft and gear in the crankcase; then install the starter
with the starter one-way bearing correctly installed, place the rotorflywheel onto the crankshaft and position the aligning
keyway with the key6Secure the rotorflywheel on the crankshaft with the nut and tighten to specifications; then install the
spring and oil-through in the crankshaft 1Install the oil pump with the arrow on the pump body directed upward; then secure
with the two cap screws and tighten securelyMake sure the shaft turns freely after installing 7Install the trigger coil and
stator coil in the right-side crankcase cover; then secure with the existing hardware and tighten securelyEWater Pump FTransmission
2Install the oil pump driven sprocket and drive chain; then secure the driven sprocket with circlip3Install the oil pump