2007 Arctic Cat DVX/Utility 250 ATV Service Manual, Page 71Get this manual

2007 Arctic Cat DVX/Utility 250 ATV Service Manual, Page 71

ATV-1085B NOTE: Note the direction of the exhaust side of the piston (5) for correct ring end gap orientation BInstall the
Components APiston BCylinder NOTE: If the piston rings were removed, install them in this sequence 1Install the piston on
the connecting rod making sure there is circlip on each side and the open end of the circlip is directed upwards or downwardsNOTE:
The piston should be installed so the IN mark is toward the intake (rear) side of the cylinder AInstall ring expander (4)
in the bottom groove of the piston; then install the thin oil rings (3) over the expander making sure the expander ends do
not overlapStagger the end gaps of the upper and lower thin oil rings according to the illustration 2Place the two alignment