2007 Arctic Cat DVX/Utility 250 ATV Service Manual, Page 89Get this manual

2007 Arctic Cat DVX/Utility 250 ATV Service Manual, Page 89

RESISTANCE (Switch Connector) RESISTANCE (Switch) ! CAUTION Always disconnect the battery when performing resistance tests
Control) The switch has spade-type connectors which engage the harness connectors at the switchNOTE: The ignition switch
must be in the ON position Coolant Temperature and Cooling Fan Switches 1Connect the meter leads (selector in the OHMS position)
to the switch contacts2Suspend the switch and thermometer in container of water; then heat the waterNOTE: Neither the switch
nor the thermometer should be allowed to touch the bottom of the container or inaccurate readings will occurUse wire holders
to suspend switch and thermometer VOLTAGE (Wiring Harness Connector) 1Set the meter selector to the DC Voltage position2Connect
the red tester lead to the brownblue wire; then connect the black tester lead to ground3The meter must show battery voltageNOTE:
If the meter shows no battery voltage, troubleshoot the battery, fuse, switch, or the main wiring harnessNOTE: If the meter