2007 Arctic Cat DVX/Utility 250 ATV Service Manual, Page 94Get this manual

2007 Arctic Cat DVX/Utility 250 ATV Service Manual, Page 94

Handlebar Control Switches Two white connectors join the handlebar control switch pigtails to the main harnessTo access the
1Set the meter selector to the OHMS position2Connect the red tester lead to the blue wire; then connect the black tester
lead to the brownblack wire3With the dimmer switch in the HI position, the meter must show less than ohmNOTE: If the meter
shows more than ohm of resistance, troubleshoot or replace the switchcomponent or the connector 1Set the meter selector to
the OHMS position2Connect the red tester lead to the greenred wire; then connect the black tester lead to the bluered wireThe
meter must show an open circuit3Depress and hold the reverse override buttonThe meter must show less than ohm of resistanceNOTE:
If the meter does not show as specified, replace the switchcomponent or connector RESISTANCE (LO Beam) 1Connect the red tester
lead to the white wire; then connect the black tester lead to the brownblack wire2With the dimmer switch in the LO position,
the meter must show less than ohmNOTE: If the meter reads more than ohm of resistance, troubleshoot or replace the switchcomponent