2007 Arctic Cat DVX/Utility 250 ATV Service Manual, Page 104Get this manual

2007 Arctic Cat DVX/Utility 250 ATV Service Manual, Page 104

8Adjust the drive chain (see Section 2); then tighten the two cap screws9Install the wheel hubs and tighten the rear wheel
rear wheels ! WARNING Make sure the ATV is solidly supported on the support stand to avoid injury 7Remove the clamp securing
the brakeline hose to the swing arm; then remove the lower rear shock absorber mounting nut and bolt 2Compress the brake
lever and engage the brake lever lock; then remove the rear wheels and hub caps3Remove the cotter pins and rear hub nuts;
then remove the hubs4Disengage the brake lever lock; then remove the rear brake calipers and brake discNOTE: Do not apply