2007 Arctic Cat DVX/Utility 250 ATV Service Manual, Page 107Get this manual

2007 Arctic Cat DVX/Utility 250 ATV Service Manual, Page 107

REPLACING SWING ARM SEALS AND BEARINGS To replace damaged or worn seals and bearings in the swing arm assembly, use the following
of the axle and install in the gear case from the left side 2Drive in new pivot bearings until fully seated; then install
new dust seals 2Install the rear axle and gear case into the right side of the swing arm; then secure the gear case to the
swing arm assembly with the eight cap screwsTighten to specifications 3Remove the three cap screws, the dust plate, and one
O-ring from the left axle housing on the swing arm; then from the right side, drive out the axle bearing 3Apply grease to