2007 Arctic Cat DVX/Utility 250 ATV Service Manual, Page 117Get this manual

2007 Arctic Cat DVX/Utility 250 ATV Service Manual, Page 117

3Remove the nut securing the hub4Remove the cap screws securing the brake caliper; then remove the caliper and lay aside
then remove the front bumperCLEANING AND INSPECTING NOTE: Whenever part is worn excessively, cracked, or damaged in any way,
replacement is necessary 6Remove the cotter pin and slotted nut securing the tie rod end to the knuckle; then remove the
tie rod end from the knuckle 1Clean the knuckle in parts-cleaning solvent; then dry with compressed airIf any damage or excessive
wear is detected, the knuckle must be replaced2Inspect the ball joint for boot damage or wearReplace the A-arm if the ball