2007 Arctic Cat DVX/Utility 250 ATV Service Manual, Page 130Get this manual

2007 Arctic Cat DVX/Utility 250 ATV Service Manual, Page 130

Front Brake Lever Master Cylinder Assembly NOTE: Critical torque specifications are located in Section 10NOTE: The master
hose to the bleed screw on either front brake caliper; then open the bleed screw and pump the brake fluid into suitable containerClose
the bleed screw ! CAUTION Brake fluid is highly corrosiveDo not spill brake fluid on any surface of the ATV INSTALLING NOTE:
Wash all master cylinder components in new brake fluid before assemblingDo not dry components 1Install the brakelight switch
on the master cylinder; then install the brake lever and brake lever lockKM116A NOTE: Do not reuse brake fluidWhen exposed
to air, brake fluid rapidly absorbs moisture 2Install the master cylinder assembly on the handlebar engaging the alignment
stud in the hole in the handlebar; then secure with the master cylinder clamp and two cap screwsMake sure the UP arrow on
the clamp is directed upward 2Remove the brakeline hose union bolt; then remove the cap screws securing the master cylinder