2007 Arctic Cat DVX/Utility 250 ATV Service Manual, Page 131Get this manual

2007 Arctic Cat DVX/Utility 250 ATV Service Manual, Page 131

2Compress the reservoir clamp and remove the reservoir hose; then remove the union boltAccount for and discard two crush
nutFinger-tighten only at this time2Secure the master cylinder to the frame with the two cap screws and tighten to specifications3Using
two new crush washers, connect the brakeline hose to the master cylinder with the union bolt; then making sure the spring
clamp is seated securely, connect the reservoir hose to the master cylinderTighten the union bolt to specifications4Making
sure the brake pedal is fully released and against the stop, turn the clevis and adjuster nut until the hole in the clevis
is aligned with the hole in the brake pedal lever; then tighten the jam nut securely REMOVING 1Connect clear plastic hose
to the appropriate bleed screw on the rear brake caliper; then loosen the bleed screw and pump the foot brake until the fluid
is pumped into suitable container ! CAUTION Brake fluid is highly corrosiveDo not spill brake fluid on any surface of the