2007 Arctic Cat Prowler/Prowler XT ATVs Service Manual, Page 6Get this manual

2007 Arctic Cat Prowler/Prowler XT ATVs Service Manual, Page 6

3Either drain the gas tank or add Fuel Stabilizer to the gas in the gas tankRemove the air filter housing cover and air filterStart
all nuts, bolts, cap screws, and screwsMake sure rivets holding components together are tightReplace all loose rivetsCare
must be taken that all calibrated nuts, cap screws, and bolts are tightened to specifications (see Section 10)8Fill the cooling
system to the bottom of the stand pipe in the radiator neck with properly mixed coolant9Disconnect the battery cables; then
remove the battery, clean the battery posts and cables, and store in clean, dry area10Store the vehicle indoors in level
position ! CAUTION Connect the positive battery cable first; then the negative 7Check the entire brake systems (fluid level,
pads, etc, all controls, headlights, taillight, brakelight, and headlight aim; adjust or replace as necessary8Tighten all
nuts, bolts, cap screws, and screws making sure all calibrated nuts, cap screws, and bolts are tightened to specifications
(see Section 10)9Check tire pressureInflate to recommended pressure as necessary10Make sure the steering moves freely and