2007 Arctic Cat Prowler/Prowler XT ATVs Service Manual, Page 18Get this manual

2007 Arctic Cat Prowler/Prowler XT ATVs Service Manual, Page 18

HEADLIGHT NutsBoltsCap Screws Tighten all nuts, bolts, and cap screwsMake sure rivets holding components together are tightReplace
the back of the headlight2Grasp the bulb socket, turn it counterclockwise and remove, and pull the bulb straight out of the
socket3Install the new bulb into the socket and rotate it completely clockwise in the housing4Install the wiring harness
connectorTAILLIGHT-BRAKELIGHT 1Attach the Timing Light (pn 0644-296) to the spark plug high tension lead; then remove the
timing inspection plug from the left-side crankcase cover2Start the engine and using the RPM function on the speedometertachometer
(XT) or using suitable tachometer (Prowler), run at 1500 RPM; ignition timing should be 10 BTDC3Install the timing inspection
plugIf ignition timing cannot be verified, the rotor may be damaged, the key may be sheared, the trigger coil bracket may
be bent or damaged, or the CDI unit may be faulty To replace the taillight-brakelight bulb, use the following procedure1Remove
the two machine screws and remove the light assembly2Rotate the bulb socket counterclockwise to remove it from the light