2007 Arctic Cat Prowler/Prowler XT ATVs Service Manual, Page 19Get this manual

2007 Arctic Cat Prowler/Prowler XT ATVs Service Manual, Page 19

2Measure the distance from the floor to the mid-point of each headlight3Using the measurements obtained in step 2, make horizontal
brake and turn the ignition switch on; then with the shift lever in the neutral position, look for the (N) indication on
the LCDShift into high range and look for the (H) indication, low range for the (L) indication, and reverse for the (R) indicationShift
the transmission into neutral and turn the ignition switch off 0740-647 7Using the adjuster knob, adjust each headlight until
correct aim is obtained ADJUSTING SHIFT LEVER LINKAGE To adjust the shift lever linkage, use the following procedureCD714A
1Set the parking brake; then remove the seats and center console2Make sure the shift lever is in neutral; then loosen the
jam nut on the linkage3Remove the E-clip on the transmission shift arm; then remove the linkage from the shift armAccount