2007 Arctic Cat Prowler/Prowler XT ATVs Service Manual, Page 22Get this manual

2007 Arctic Cat Prowler/Prowler XT ATVs Service Manual, Page 22

EInstall the wheelTighten to specifications (see Section 10)5Burnish the brake pads (see Burnishing Brake Pads in this section)
piston; then rotate counterclockwise approximately one spline To adjust (set up) the parking brake, use the following procedureNOTE:
Remove the four rear body screws securing the belly panel to the frame and allow it to drop down for better access to the
parking brake actuator 3Install the actuator lever in the position noted in step 1; then install the actuator nut and tighten
to 4.8 kg-m (35 ft-lb) 1Remove the parking brake cable from the actuator lever; then remove the actuator nut and actuator