2007 Arctic Cat Prowler/Prowler XT ATVs Service Manual, Page 23Get this manual

2007 Arctic Cat Prowler/Prowler XT ATVs Service Manual, Page 23

! CAUTION If after adjusting the parking brake cable the parking brake will not hold the vehicle, the brake pads must be
and allow the cargo box to tilt all the way back Installing 1Place the brake pads into the caliper; then install the anti-rattle
springsNOTE: The metal backing of the pad will be facing the actuator when installed properly 3Remove the two cap screws
securing the brake caliper to the rear drive housing and remove the caliper 2Slide brake caliper assembly over the brake
disc and into position on the knuckle; then secure the caliper with the cap screws tightened to specifications (see Section
10)3Connect the parking brake cable (see Adjusting in this sub-section)4Adjust the parking brake (see Adjusting in this sub-section)5Connect