2007 Arctic Cat Prowler/Prowler XT ATVs Service Manual, Page 25Get this manual

2007 Arctic Cat Prowler/Prowler XT ATVs Service Manual, Page 25

4Install one of the V-belt cover cap screws into the driven pulley fixed face; then turn the driven pulley clockwise to
damage to the shaft and pulley NOTE: At this point, remove the cap screw from the driven pulley fixed face INSTALLING 1Place
the V-belt into position on the driven pulley and over the front shaft 3Rotate the V-belt and driven pulleyclutch until the
V-belt is flush with the top of the driven pulley4Place the V-belt cover gasket into position; then install the cover and
secure with the cap screws making sure the different-lengthed cap screws are in their proper locationTighten the cap screws
to specifications (see Section 10)5Secure the seat-base with the four cap screwsTighten securely6Install the seats and center