2007 Arctic Cat Prowler/Prowler XT ATVs Service Manual, Page 28Get this manual

2007 Arctic Cat Prowler/Prowler XT ATVs Service Manual, Page 28

(Table of Contents) Removing EngineTransmission 3-3 Top-Side Components3-7 Removing Top-Side Components 3-7 Right-Side Components
informationPR156A 3Remove the negative cable from the battery; then remove the positive cable4From the left-side, remove
the spark plug cap; then disconnect the temperature sensor lead, speed sensor connector (XT), fuel level sensor connector
(XT), and reverse override switch connector AT THIS POINT If the technician's objective is to servicereplace left-side cover
oil seals (3), front output joint oil seal (1), rear output joint oil seal (1), andor the oil strainer (from beneath the
engine transmission), the enginetransmission does not have to be removed from the frame Support the vehicle on suitable lift
or jack stands allowing room to perform work from the undersideNOTE: Locate the jack stands to allow removing of the center
belly panel ! WARNING Make sure the vehicle is solidly supported on the support stands to avoid injuryPR130A 1Remove the