2007 Arctic Cat Prowler/Prowler XT ATVs Service Manual, Page 36Get this manual

2007 Arctic Cat Prowler/Prowler XT ATVs Service Manual, Page 36

NOTE: Support the connecting rod with rubber bands to avoid damaging the rod or install the Connecting Rod Holder (pn 0444-006)
ring, slide one end of the ring out of the ring-grooveBRemove each ring by working it toward the dome of the piston while
rotating it out of the groove AT THIS POINT To service piston, see Servicing Top-Side Components sub-section AT THIS POINT
To service center crankcase components only, proceed to Removing Left-Side ComponentsPR465 Right-Side Components NOTE: For
efficiency, it is preferable to remove and disassemble only those components which need to be addressed and to service only
those componentsThe technician should use discretion and sound judgment 3Using cold chisel, scribe mark showing the relative
position of the shift arm to the shift arm shaft to aid in installing; then remove the shift arm AT THIS POINT To service
any one specific component, only limited disassembly of components may be necessaryNote the AT THIS POINT information in