2007 Arctic Cat Prowler/Prowler XT ATVs Service Manual, Page 37Get this manual

2007 Arctic Cat Prowler/Prowler XT ATVs Service Manual, Page 37

5Loosen the clamps securing the coolant hose to the water pump; then remove the crossover tube from the cylinder headAccount
the cap screws securing the right-side cover to the crankcase noting the location of the different-sized cap screws for installing
purposes8Using Side Case Puller (pn 0644-262), remove the side coverAccount for gasket and two alignment pinsNOTE: Inspect
the inside of the right-side cover for any shaft washers that may have come off with the coverMake sure they are returned
to their respective shafts and that the starter idler gear spacer is on the shaft or in the cover AT THIS POINT To service