2007 Arctic Cat Prowler/Prowler XT ATVs Service Manual, Page 44Get this manual

2007 Arctic Cat Prowler/Prowler XT ATVs Service Manual, Page 44

3Remove the shift shaft (H); then remove the two forks taking note of the direction of the tabs on the forks for assembling
is flat spot on the crank balancer bearing flange to allow clearance past the crankshaft 5Remove the countershaft assembly
(D)Account for washer on each end of the countershaft NOTE: Do not disassemble the countershaft assembly unless necessaryIf
necessary, see Servicing Center Crankcase Components sub-section 9Remove the snap ring securing the water pump driven gear