2007 Arctic Cat Prowler/Prowler XT ATVs Service Manual, Page 45Get this manual

2007 Arctic Cat Prowler/Prowler XT ATVs Service Manual, Page 45

11Remove the cap screws securing the oil strainer cap; then remove the capAccount for the cap O-ring CC686 Table of Contents
Do not remove the remaining output shaft assembly unless absolutely necessaryIf the shaft is removed, the shaft nut must
be replaced with new one and the shaft must be re-shimmed 13To remove the assembly, remove the nut securing the secondary
drive gear and secondary driven gear; then from the inside of the crankcase using rubber mallet, remove the output shaft
assemblyAccount for the output shaft, two gears, shim, washer, and the nut Servicing Top-Side Components NOTE: Whenever part
is worn excessively, cracked, or damaged in any way, replacement is necessary VALVE ASSEMBLY When servicing valve assembly,
inspect valve seats, valve stems, valve faces, and valve stem ends for pits, burn marks, or other signs of abnormal wearNOTE: