2007 Arctic Cat Prowler/Prowler XT ATVs Service Manual, Page 49Get this manual

2007 Arctic Cat Prowler/Prowler XT ATVs Service Manual, Page 49

2Remove each ring by working it toward the dome of the piston while rotating it out of the grooveNOTE: If the existing rings
sharp edge2Using the sharpened ring as tool, clean carbon from the ring-groovesBe sure to position the ring with its tapered
side up ! CAUTION Improper cleaning of the ring-grooves by the use of the wrong type of ring-groove cleaner will result in
severe damage to the pistonATV-1070 Measuring Piston-Ring End Gap (Installed) 2Insert an inside dial indicator into the piston-pin
boreThe diameter must not exceed specificationsTake two measurements to ensure accuracy 1Place each compression ring in the