2007 Arctic Cat Prowler/Prowler XT ATVs Service Manual, Page 52Get this manual

2007 Arctic Cat Prowler/Prowler XT ATVs Service Manual, Page 52

NOTE: To produce the proper 60 cross-hatch pattern, use low RPM drill (600 RPM) at the rate of 30 strokes per minuteIf honing
seizure marks, or pitting is found, the cylinder head assembly must be replacedMeasuring Camshaft to Cylinder Head Clearance
1Remove the adjuster screws and jam nuts 1Place the camshaft on set of blocks; then position the dial indicator contact point
against the shaft and zero the indicator 2Place strip of plasti-gauge in each of the camshaft lands in the cylinder headCC283D
2Rotate the camshaft and note runout; maximum tolerance must not exceed specificationsMeasuring Camshaft Lobe Height 3Place
the valve cover on the cylinder head and secure with the valve cover cap screwsTighten securelyNOTE: Do not rotate the camshaft