2007 Arctic Cat Prowler/Prowler XT ATVs Service Manual, Page 55Get this manual

2007 Arctic Cat Prowler/Prowler XT ATVs Service Manual, Page 55

6Using spanner and suitable breaker bar, loosen the notched-ring nut; then spin the nut free of the hub CD067 4Using suitable
holding handle on the spring holder fitting the two dowel pins into the spring holder face; then install flat washer and
the wing nutTurn the wing nut down until resistance is feltNOTE: Do not use the wing nut to compress the spring further 8Release
the preload slowly; then continue to relax the spring until the wing nut is flush with the end of the threads9Firmly holding
the spring and spring holder, remove the wing nut; then remove the spring ! WARNING The spring assembly is under pressureExtreme