2007 Arctic Cat Prowler/Prowler XT ATVs Service Manual, Page 57Get this manual

2007 Arctic Cat Prowler/Prowler XT ATVs Service Manual, Page 57

2Apply multi-purpose grease to the O-rings and grease seals on the movable face; then install on the fixed face making sure
on the pulley compressor bolt; then thread the wing nut onto the boltCF095A 4Install the movable face sleeve aligning the
hole in the spring seat with the spring anchor hole in the movable face 5Install the spring over the hub and movable face
sleeve; then insert the end of the spring through the sleeve and into the spring anchor hole in the movable face 8Compress
the spring until the spring holder nears the threads on the fixed face hub; then using the handle, wind the spring holder