2007 Arctic Cat Prowler/Prowler XT ATVs Service Manual, Page 58Get this manual

2007 Arctic Cat Prowler/Prowler XT ATVs Service Manual, Page 58

Checking Backlash NOTE: The rear shaft and bevel gear must be removed for this procedureAlso, always start with the original
measurement is less than specified, remove an existing shim, measure it, and install new thinner shim2If backlash measurement
is more than specified, remove an existing shim, measure it, and install thicker shimCD066 11Remove the wing nut, washer,
and holding handle; then remove the driven pulley from the pulley compressor NOTE: Continue to remove, measure, and install
until backlash measurement is within toleranceNote the following chartBacklash Measurement Under 0.05 mm (0.002 in Shim Correction
Decrease Shim Thickness No Correction Required Increase Shim Thickness Servicing Center Crankcase Components NOTE: Whenever
part is worn excessively, cracked, damaged in any way, or out of tolerance, replacement is necessary At 0.05-0.33 mm (0.002-0.013
in Over 0.33 mm (0.013 in Checking Tooth Contact NOTE: After correcting backlash of the secondary driven bevel gear, it is