2007 Arctic Cat Prowler/Prowler XT ATVs Service Manual, Page 60Get this manual

2007 Arctic Cat Prowler/Prowler XT ATVs Service Manual, Page 60

Measuring Connecting Rod (Small End Deflection) 1Place the crankshaft on set of V-blocks and mount dial indicator and base
crankshaft 4Maximum runout must not exceed specificationsNOTE: Proceed to check runout on the other end of the crankshaft
by positioning the indicator contact at point and following steps 2-4 Measuring Crankshaft (Web-to-Web) 1Using calipers,
measure the distance from the outside edge of one web to the outside edge of the other webCC289D 3Acceptable gap range must
be within specificationsMeasuring Connecting Rod (Big End Width) 1Using calipers, measure the width of the connecting rod
at the big-end bearing2Acceptable width range must be within specificationsMeasuring Crankshaft (Runout) ATV-1017 2Acceptable
width range must be within specifications 1Place the crankshaft on set of blocks2Mount dial indicator and base on the surface