2007 Arctic Cat Prowler/Prowler XT ATVs Service Manual, Page 61Get this manual

2007 Arctic Cat Prowler/Prowler XT ATVs Service Manual, Page 61

COUNTERSHAFT Assembling ! CAUTION When disassembling the countershaft, care must be taken to note the direction each major
(5), circlip (4), reverse driven gear dog (3), and drive gear #2 (2); then install the right drive gear washer (17)121314151617Low
Driven Gear Driven Gear Washer Sliding Dog High Driven Gear Drive Gear Washer (L) Drive Gear Washer (R) 739-954A NOTE: When
installing the countershaft assembly, account for the washer on each end of the shaft Assembling Crankcase Half 1Install
the output shaft assembly into the crankcase making sure the two gears, shim, washer, and nut are properly sequenced Disassembling
From the right side: 1Remove the right drive gear washer (17); then remove drive gear #2 (2)2Remove the reverse driven gear
dog (3); then remove the circlip (4)3Remove the reverse driven gear spacer (5); then remove the circlip (4)4In order, remove
washer (6), reverse driven gear (7), bearing (8), and bushing (9)5In order, remove washer (6), lock washer (10, lock washer