2007 Arctic Cat Prowler/Prowler XT ATVs Service Manual, Page 63Get this manual

2007 Arctic Cat Prowler/Prowler XT ATVs Service Manual, Page 63

11Install the front and rear secondary driven shaft assemblies into the left side of the crankcase making sure the bearing
the oil strainer into position; then secure with the two screws13Place the oil strainer cap into position making sure the
O-ring is in position; then secure the cap with cap screwsTighten securely Joining Crankcase Halves 1Apply High-Temp Sealant
to the right-side mating surface2Lightly oil all bearings and grease all shafts in the left-side crankcaseCC669 10Install
the reverse idler gear assembly noting the positioning of the two washers, gear, bushing, and shaft 3Using propane torch,
heat the left-side crankshaft bearing until the oil begins to smoke; then join the two crankcase halves CC695 CC668 4Using