2007 Arctic Cat Prowler/Prowler XT ATVs Service Manual, Page 72Get this manual

2007 Arctic Cat Prowler/Prowler XT ATVs Service Manual, Page 72

5Install the coolant hose onto the crankcase union and tighten the clampCCylinder Head DValve Cover KEY 1Cylinder Head Assy
guide into the cylinder ! CAUTION Care should be taken that the bottom of the chain guide is secured in the crankcase boss
9Loosely install the five cylinder head nuts10In crisscross pattern, tighten the four cylinder head cap screws (from step
8) to 5.5 kg-m (40 ft-lb); then tighten the mm nut (from step 9) to 2.5 kg-m (18 ft-lb)Using crisscross pattern, tighten
the mm nuts (from step 9) to 1.1 kg-m (8 ft-lb)Tighten the two cylinder-to-crankcase nuts (from step 4) securelyCC022D 7Place
the head gasket into position on the cylinderPlace the alignment pins into position; then place the head assembly into position
on the cylinder 11With the timing inspection plug removed and the chain held tight, rotate the crankshaft until the piston