2007 Arctic Cat Prowler/Prowler XT ATVs Service Manual, Page 73Get this manual

2007 Arctic Cat Prowler/Prowler XT ATVs Service Manual, Page 73

12With the alignment pin installed in the camshaft, loosely place the cam sprocket (with the recessed side facing the cam
lobes directed down (toward the piston)CCamshaft alignment marks parallel to the valve cover mating surfaceCD461 14With the
cam lobes directed down (toward the piston), maneuver the camshaftsprocket assembly through the chain and towards its seating
position; then loop the chain over the sprocketNOTE: Note the position of the alignment marks on the end of the camshaftThey
must be parallel with the valve cover mating surfaceIf rotating the camshaft is necessary for alignment, do not allow the
chain and sprocket to rotate and be sure the cam lobes end up in the down position DRecessed side of the sprocket directed
toward the cam lobesECamshaft alignment pin and sprocket alignment hole (smallest) are aligned ! CAUTION If any of the above