2007 Arctic Cat Prowler/Prowler XT ATVs Service Manual, Page 83Get this manual

2007 Arctic Cat Prowler/Prowler XT ATVs Service Manual, Page 83

6Lift the float assembly from the carburetorAccount for the float valve CLEANING AND INSPECTING NOTE: Whenever part is worn
threads, and any other imperfections in the casting 7Secure the needle jet holder with wrench; then remove the main jet8Remove
the needle jet holder; then remove the needle jet, slow jet, and the starter jet9Remove the pilot screwAccount for spring,
washer, and an O-ring 6Inspect the vacuum pistondiaphragm for cracks, imperfections in the casting, or cracks and tears in
the rubber7Inspect float for damage8Inspect gasket and O-rings for distortion, tears, or noticeable damage9Inspect tips of
the jet needle, pilot screw, and the needle jet for wear, damage, or distortion10Inspect the slow jet and main jet for obstructions
or damageNOTE: If the slow jet is obstructed, the mixture will be extremely lean at idle and part-throttle operation 11Inspect