2007 Arctic Cat Prowler/Prowler XT ATVs Service Manual, Page 84Get this manual

2007 Arctic Cat Prowler/Prowler XT ATVs Service Manual, Page 84

ASSEMBLING 1Thread the idle adjust screw assembly into the carburetor making sure the washer and spring are properly positioned2Install
during assembling procedures 6Place the float chamber into position making sure the O-ring is properly positioned; then secure
with the Phillips-head screws 3Install the slow jetTighten securely4Install the main jet into the needle jet holder and tighten
securely; then install the needle jet and needle jet holder assembly into the carburetor and tighten securely5Place the float
assembly (with float valve) into position and secure to the carburetor with the float pin 7Place the U-ring into the pump