2007 Arctic Cat Prowler/Prowler XT ATVs Service Manual, Page 90Get this manual

2007 Arctic Cat Prowler/Prowler XT ATVs Service Manual, Page 90

8Install the left-side seat-base; then install the center console and seats making sure the seats lock securelyNOTE: If the
in the Oil Cooler sub-section) 1Remove the oil pump from the engine (see Right-Side Components in Section 3)2Remove the Phillips-head
screw on the back side of the pump and separate the pump housing and coverNote the position of the inner and outer rotors
and alignment pin for assembly3Remove oil pump componentsPR267A 3Set the parking brake and start the engineAllow the engine
to warm up to operating temperature (with cooling fan cycling)4Set the speedometertachometer to RPM (XT) or connect suitable
tachometer (Prowler)With the engine running at 2500 RPM, the pressure gauge must show 4.2-5.6 kgcm2 (60-80 psi)NOTE: If the
gauge readings are normal but low oil pressure was noted while testing the oil pump pressure, the oil cooler is plugged and
must be replaced CLEANING AND INSPECTING NOTE: Whenever part is worn excessively, cracked, or damaged in any way, replacement