2007 Arctic Cat Prowler/Prowler XT ATVs Service Manual, Page 94Get this manual

2007 Arctic Cat Prowler/Prowler XT ATVs Service Manual, Page 94

4Place the storage box into position and using smooth, flat pry-bar, pry the center of the box past the dash mount; then
replaced every four years or 4000 miles 5Slide the dash forward into position; then secure the dash with the appropriate
hardware6Install the jam nut and parking brake release handle; then tighten the jam nut so the handle is correctly oriented7Set
the parking brake; then start the engine and let idle for approximately one minute to fill the oil coolerShut the engine
off and add oil to the crankcase as required to the specified level (see Section 2) INSTALLING 1Place the thermostat into
the thermostat housing; then secure the thermostat housing to the cylinder head with the two cap screws ! CAUTION When installing
the thermostat, make sure the bleed holes are straight up and down or air will remain trapped causing engine damage due to
overheating 8Start the engine and warm up to operating temperature; then check that the coolant level is at the specified