2007 Arctic Cat Prowler/Prowler XT ATVs Service Manual, Page 99Get this manual

2007 Arctic Cat Prowler/Prowler XT ATVs Service Manual, Page 99

Specifications ProwlerXT IGNITION Ignition Timing Spark Plug Type Spark Plug Gap Spark Plug Cap Ignition Coil Resistance
and tight, that the battery is fully charged, and that all appropriate switches are activatedNOTE: For absolute accuracy,
all tests should be made at room temperature of 68 F Ignition Coil Peak Voltage Magneto Coil Resistance (primaryCDI) MAGNETO
(trigger) (source) (charging) Magneto Coil Peak Voltage (trigger) (source) (no load) Accessory ReceptacleConnector NOTE:
This test procedure is for either the receptacles or the connectors Stator Coil Output Magneto Output VOLTAGE Battery For
battery-related information, see Section 2 1Turn the ignition switch to the ON position; then set the meter selector to the
DC Voltage position2Connect the red tester lead to the redwhite wire or the positive connector; then connect the black tester
lead to ground3The meter must show battery voltage RPM Limiter NOTE: The ProwlerXT models are equipped with CDI unit that
retards ignition timing when maximum RPM is approachedWhen the RPM limiter is activated, it could be misinterpreted as high-speed