2007 Arctic Cat Prowler/Prowler XT ATVs Service Manual, Page 100Get this manual

2007 Arctic Cat Prowler/Prowler XT ATVs Service Manual, Page 100

VOLTAGE (Wiring Harness Connector) 1Set the meter selector to the DC Voltage position2Connect the red tester lead to the
switch contacts2Suspend the switch and thermometer in container of water; then heat the waterNOTE: Neither the switch nor
the thermometer should be allowed to touch the bottom of the container or inaccurate readings will occurUse wire holders
to suspend switch and thermometer RESISTANCE (Switch Connector) ! CAUTION Always disconnect the battery when performing resistance
tests to avoid damaging the multimeter NOTE: The brake pedal must be depressed for this test 1Set the meter selector to the
OHMS position2Connect the red tester lead to one black wire; then connect the black tester lead to the other black wire 733-554E
3On the coolant temperature switch when the water temperature reaches 112-118 (234-244 F), the meter should show closed circuit